atomic_fungus (atomic_fungus) wrote,
atomic_fungus
atomic_fungus

#5915: Are you f-ing kidding me

Working on the computer room--

Og suggested using sanding screen for the drywall work, so I stopped at Ace to pick up one just to try it out. Sanding screen has holes in it; what you do is slap that onto the sander, then hook a vacuum cleaner up to the discharge port on the thing. Keeps the dust down.

And I need something really aggressive, because apparently I was on drugs when I did the patch in the ceiling and plastered the spackle on as if I were sealing Fortunato into his tomb. I got 80 grit. I'll zip tie an old sock onto the discharge port on the sander to trap the dust from that.

Anyway, I did a second coat of spackle to even out the rough edges and smooth everything over. I'll sand it tomorrow and then hopefully I can paint the ceiling sometime this week. Getting that patch finished is the only thing preventing that.

Turned my attention to the north wall, what I can reach of it. Old curtains (which I replaced, at Mom's behest, in 2008) were held in with the same stupid mollyscrews that the ones in the family room had been secured with. Why, I don't know; when you're framing a window there's supposed to be studs on all sides and this is right up against the trim, which ain't that wide. But whatev.

Cracks above and below window, spackled and reinforced with fiberglas mesh. Filled the holes where the mollyscrews were after drilling them out.

Did other work on the wall, what I could reach, divots and dings, etc. Decided to pull the outlet adapter off; I use a six-into-two adapter to make sure there are enough sockets for all the computer stuff. Unscrewed it, intending to unplug the UPSes and plug them right back in...only when I pulled the adapter off, one of the socket plates came with it.

Had a spare on hand, so I wearily shut down the computers, then went downstairs to turn off power to the room so I could replace the socket. Once that was done, powered everything back on, and we're good. Fine.

I did not get as much done today as I'd hoped, but I got most of the spackle on the S wall sanded smooth, as well as the other stuff I previously mentioned doing.

Tomorrow, once the ceiling patch is sanded, I'm going to work on the E wall almost exclusively, pulling down pictures and spackling. Make sure everything is good to go there, and then finish work on the N wall. The S wall is where Mrs. Fungus' computer is, and I'm waiting for her to pack up her desk stuff so I can move it with impunity.

Sure would be nice if I could get this room finished some time in the next week. We'll see how we do, of course, but it would be awfully nice.

* * *

Haven't we heard this from John McCain before? I don't trust him any further than I could comfortably piss a Grehouse AmeriCruiser. I'm sure he'd rather torpedo anything with Trump's name on it.

* * *

These things usually turn out to be hoaxes. So, until it's proven otherwise....

* * *

Tonight is chili night. First time I've made it in a while. Well--turned the heat on a scant week ago; I'd set the thermostat low because I had the windows open yesterday, and it was 66° in here when I got up to take Maki to his vet appointment. It's October and we have cold nights; now's the time for chili!
Subscribe

  • #7561: Busy, though pleasant

    Sunday, I changed the oil in Mrs. Fungus' car, assembled a new cat tree, and--spur of the moment--decided to bake Irish Soda Bread. Then washed the…

  • #7560: Trying enchiladas again

    Different recipe. We were supposed to go shopping last night, but Mrs. Fungus left her purse and both her personal and work phones at the office and…

  • #7559: Post-constitutional oligarchy?

    I don't know where to start with all this. I guess we can go, first off, with the democrat bill to nationalize all elections. It basically removes…

  • Post a new comment

    Error

    default userpic

    Your reply will be screened

    Your IP address will be recorded 

    When you submit the form an invisible reCAPTCHA check will be performed.
    You must follow the Privacy Policy and Google Terms of use.
  • 0 comments